EN
66
12 Parameter's index
PARAM.
FACTORY
VALUE
DESCRIPTION PAGE
$
see chap. 13
Selecting automation system model 68
$
Automatic closure after pause time (from gate completely open) 68
$
Automatic gate closing after mains power outage 68
$
Selecting step mode control function (PP) 68
$
5WJܫFXMNSL 68
$
Condominium function for partial open command (PED) 69
$
Enabling operator present function 69
$
Gate open indicator / photocell test function and “battery saving” 69
Setting deceleration during opening (and closing for BG30/1600 - BG30/2200)69
Setting deceleration during closing (High Speed and Reversible Motors only) 69
Setting gate open limit switch constant speed approach distance 69
Setting gate closed limit switch constant speed approach distance 69
Partial opening adjustment (%) 69
Type of signaling provided by COR output 69
Setting automatic closing time 69
Enabling of management for opening with automatic re-closure exclusion 70
Setting reverse time after activation of sensing edge or obstacle detection (crush
prevention)
70
Setting motor torque 70
Setting obstacle impact force sensitivity 70
Setting start acceleration during opening (and closing for BG30/1600 -
BG30/2200)
70
Setting start acceleration during closing (High Speed and Reversible Motors
only)
70
Enabling maximum torque boost at start of manoeuvre 70
Setting motor torque during position recovery 71
Setting opening speed (and closing for BG30/1600 - BG30/2200)71
Setting closing speed (High Speed and Reversible Motors only) 71
Setting end of manoeuvre constant approach speed 71
Setting number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
71
Setting photocell mode during gate opening (FT1) 71
Setting photocell mode during gate closing (FT1) 71
Photocell (FT1) mode with gate closed 71
Setting photocell mode during gate opening (FT2) 71
Setting photocell mode during gate closing (FT2) 72
To Next Page
Loading...
