Replacing the MOTHERBOARD (1100.2352.02) R&S CMU
1100.4903.82 3.70 E-5
Replacing the MOTHERBOARD (1100.2352.02)
(see chapter 5, spare part list, Current No. 1202 (MOTHERBOARD) and explosion drawing
1100.0008.01 D sheet 2)
The MOTHERBOARD consists of four parts: MOTHERBOARD1, MOTHERBOARD2, FRONTPANEL
BOARD and REARPANEL BOARD2.
For replacement of the individual parts proceed as follows:
MOTHERBOARD1 (big MOTHERBOARD)
Opening the instrument and removing MOTHERBOARD1
Switch off the instrument, pull the mains plug and unscrew the rear-panel feet.
Place the instrument onto the front carrying handles, push the tube upwards and take off.
After unscrewing the two countersunk screws at the top left instrument frame slightly lift the cover at
the top of the instrument, slightly shift towards the right and lift off.
Loosen all connecting cables to the boards, then lever out all boards as described above using the
two levers at the right and at the left.
Likewise, remove the POWER SUPPLY and the FRONT MODULE, disconnect the ribbon cable
connections to the RF-FRONTEND, MOTHERBOARD2, FRONTPANEL BOARD and REARPANEL
BOARD2. Disconnect the fan connecting cable and remove the Option OCXO REFERENCE OSC, if
installed.
Place the instrument upside down and unscrew all the eleven combi screws on MOTHERBOARD1
and the holder for the I/O Connectors on the backside of the instrument, then slightly shift
MOTHERBOARD1 towards the front and swing out MOTHERBOARD1 towards the top.
Installing the new MOTHERBOARD1 and completing the instrument
Insert new MOTHERBOARD1 and connect all connectors and modules in the reverse order.
Complete the instrument without causing damage to the cables.
Connect the instrument to the mains and switch on.
To Next Page
Loading...
Need help?
General
