Rohde & Schwarz CMU 200 Service Manual

Safety Instructions
1171.0300.62 E-1
WARNING
Danger of injuries
When removing the rear feet, the unit can slip out of the cabinet.
Put the unit onto the front handles, before removing the rear feet and taking off the
cabinet. Thus the risk of personal injuries and damages to the unit is avoided.
When mounting the cabinet take care not to pen in the fingers. Also pay attention not
to damage or pull off cables. Screw the rear feet back on immediately after mounting
the cabinet. Do not move the unit with the rear feet missing.
ATTENTION
To avoid damage of electronic components, the operational site must be protected against
electrostatic discharge (ESD).
Wrist strap with cord
Building ground
Ground connection
of operational site
Heel strap
Floor mat
The following two methods of ESD protection may be used together or separately:
• Wrist strap with cord to ground connection
• Conductive floor mat and heel strap combination

Rohde & Schwarz CMU 200 Specifications

General

Brand	Rohde & Schwarz
Model	CMU 200
Category	Test Equipment
Language	English