Software and Firmware Update
R&S
®
EB510
44Getting Started 4091.7338.02 ─ 01
If the USB flash drive can be detected by BIOS, as shown in the screenshot below,
select the USB flash drive as the "Boot First" device.
If BIOS does not recognize the USB flash drive, select "Bootable Add-in Cards" and
press ENT to enable booting from the USB flash drive.
The first boot device, which starts with "Ch2 S" is the internal drive of the
R&S EB510. If this is selected by mistake, the R&S EB510 will start up as normal
and the GUI Update procedure should be restarted.
In the next dialog select "Update" using the CURSOR LEFT / CURSOR RIGHT or
ROTARY KNOB and the ENT key. See chapter 2.1, "Front-Panel
Tour", on page 12.
Receiver Firmware and GUI Update for EB510 with front control panel
To Next Page
Loading...
