Rohde & Schwarz FSH20 - 8 Receiver Mode (R&S FSH-K43)

R&S FSH Receiver Mode (R&S FSH-K43)
Analyzing Measurement Results
Operating Manual 1173.6275.12 - 30 231
8 Receiver Mode (R&S FSH-K43)
Equipped with firmware option R&S FSH-K43 (order no. 1304.5635.02), you can
perform receiver and channel measurements (or scans) with your R&S FSH.
In receiver mode, the R&S FSH measures the power level of a particular frequency or
a customized set of frequencies instead of sweeping over (parts of) the frequency
spectrum. The R&S FSH shows the scan results in result displays that have been
designed for just such measurement tasks.
The receiver mode also adds the necessary functions like bandwidths or detectors to
perform measurements according to CISPR.
By default, the R&S FSH is in the operating mode you have been in last after you have
turned it on. To switch to the receiver mode from another operating mode, proceed as
follows.
► Press the MODE key.
► Press the "Receiver Mode" softkey.
The R&S FSH starts the receiver mode in single frequency measurement mode.