Rohde & Schwarz FSH20 - The Burst Power Result Display

R&S FSH Digital Modulation Analyzer
Measurements on 1xEV-DO Signals
Operating Manual 1173.6275.12 - 30 290
9.6.3 The Burst Power Result Display
If you equip the R&S FSH with option R&S FSH-K47E, the Burst Power result display
becomes available.
The Burst Power result display shows the power of the signal over a single 1xEV-DO
frame (26.66 ms). This measurement is necessary to check if the power and timing of
the bursted signals meets the requirements of the standard.
In order to capture a complete frame, you can apply a trigger from a GPS device or
another external trigger.