R&S FSP Module Replacement
1164.4556.82 3.61 E-1
Replacing Compact Flash Board S-ATA A60 (Option R&S FSP-B18)
(See chapter 5, spare parts list, item 4900)
Opening the Instrument and Removing the Compact Flash Board
Switch unit off, disconnect it from AC supply, unscrew 4 rear-panel feet (450), and pull off enclosure
(410) toward the rear.
Remove top cover (240) of instrument as follows: Unscrew 2 countersunk screws (260) on upper
side of cover and 3 countersunk screws (250) on fan side, then swing out cover to the left and
remove it.
Remove 4 screws (430) at left and right front handles (420) and take off front handles.
Pull off front cover (292) toward the front.
Remove Compact Flash Card (4910).
Disconnect cable W29 (4962) and cable W30 (4963) at Compact Flash Board (4900).
Remove 3 screws and washers (4950) at the adapter plate (4940).
Pull out the CF Card Holder (4920) with Board (4900) to the front.
Dismount 4 screws and washers (4930) and remove the Compact Flash Board (4900)
To Next Page
Loading...
