Rohde & Schwarz FSP3 - Software Update; Installing Options; Installation of New R&S FSP Software

R&S FSP Installation of new R&S FSP Software
1164.4556.82 4.1 E-1
4 Software Update / Installing Options
T
his chapter contains information on updating software, restoring the operating-system installation and
installing options to the R&S FSP. Additional manuals obtained together with a software/firmware update
or with subsequently acquired options can be filed here.
Installation of new R&S FSP Software
The installation of a new firmware version can be performed using the built-in diskette drive. The
firmware update kit contains several diskettes.
The installation program is called up in the SETUP menu.
SETUP side menu:
FIRMWARE
UPDATE
The FIRMWARE UPDATE softkey starts the installation program and
leads the user through the remaining steps of the update
IEC/IEEE-bus command: --
Performing the update:
Insert diskette 1 into the drive.
Call SETUP side menu [SETUP][NEXT]
Start update [FIRMWARE UPDATE]
RESTORE
FIRMWARE
The RESTORE FIRMWARE softkey restores the previous firmware
version
IEC/IEEE-bus command: --