R&S FSP Installing the Options
1164.4556.82 4.3 E-1
Installing the Options
The following options are available with the R&S FSP:
A
F Demodulator R&S FSP-B3 1129.6491.02
OCXO Reference R&S FSP-B4 1129.6740.02
TV Trigger / RF Power Trigger R&S FSP-B6 1129.8594.02
Tracking Generator R&S FSP-B9 1129.6991.02
External Generator Control R&S FSP-B10 1129.7246.03
WCDMA Demodulation Hardware R&S FSP-B15 1155.1006.02
LAN Interface R&S FSP-B16 1129.8042.02
Removable Hard Disk R&S FSP-B18 1163.0892.03
Flash Disk R&S FSP-B20 1155.1606.10
Externer Mischer (nur für R&S FSP 40) R&S FSP-B21 1155.1758.02
Elektronic Attenuator R&S FSP-B25 1129.7746.02
Trigger Port R&S FSP-B28 1162.9915.02
DC Power Supply R&S FSP-B30 1155.1158.02
Battery Pack R&S FSP-B31 1155.1258.02
Additional Battery Pack R&S FSP-B32 1155.1506.02
Demodulation Hardware R&S FSP-B70 1157.0559.02
For retrofitting, please note the mounting instructions enclosed with the options.
These mounting instructions can be filed at this place in the service manual and are thus easily available
whenever they are required.
CAUTION
Disconnect the instrument from the mains before opening the casing. Also note the
safety instructions at the beginning of this manual.
The components used in the instrument are sensitive to electrostatic discharges
which is why they are to be dealt with according to the ESD regulations
When installing hardware options note the following:
Switch off instrument and pull the mains plug.
Unscrew the 4 rear-panel feet (450) and push the tube (410) backwards and take off.
After installing the option replace the tube and fasten the rear panel feet again.
CAUTION
When replacing the tube take care not to damage or pull off cables
To Next Page
Loading...
