Rohde & Schwarz FSWP - Removable Hard Disk; AC Power Supply Connection and Main Power Switch; Display Port and DVI

Instrument Tour
R&S
®
FSWP
46Getting Started 1177.5756.02 ─ 13
● IF / Video / Demod Output...............................................................................47
● IF Wide Out..................................................................................................... 47
● Sync Trigger Input and Output........................................................................ 48
● AUX Port......................................................................................................... 48
● GPIB Interface.................................................................................................49
● External Generator Control (Optional)............................................................ 49
● OCXO (Optional).............................................................................................49
● REF INPUT / REF OUTPUT........................................................................... 50
● Labels on R&S FSWP.....................................................................................51
● Device ID.........................................................................................................51
4.2.1 Removable Hard Disk
The removable hard disk is accessible from the rear of the instrument.
In addition to the operating system and the firmware, the R&S FSWP also stores
measurement data on that disk. When you remove the hard disk, you can store it
and the data on it somewhere secure.
4.2.2 AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on
the rear panel of the instrument.
Main power switch function:
Position 1: The instrument can be started via the Power key on the front panel.
The (optional) OCXO reference frequency is warmed up.
Position O: The entire instrument is disconnected from the AC power supply.
For details, refer to "Connecting to power" on page 11 and Chapter 3.5, "Connect-
ing the AC Power", on page 20.
4.2.3 Display Port and DVI
You can connect an external monitor or other display device to the R&S FSWP to
provide an enlarged display. Two different types of connectors are provided for
this purpose:
●
Display Port
The Rear Panel