Operating the Instrument
R&S
®
FSWP
79Getting Started 1177.5756.02 ─ 13
Spur removal Spur removal characteristics. Only displayed if spur removal has been
turned on for a trace.
Trace offset Trace offset characteristics. Only displayed if an offset has been
defined for a trace.
6.1.3 Marker Information
Marker information is provided either in the diagram grid or in separate marker
tables, depending on the configuration.
Marker information in diagram grid
Within the diagram, the x-axis and y-axis positions of the last 2 markers or delta
markers that were set are displayed, if available, as well as their index. The value
in the square brackets after the index indicates the trace to which the marker is
assigned. (Example: M2[1] defines marker 2 on trace 1.) For more than 2 mark-
ers, a separate marker table is displayed beneath the diagram by default.
Marker information in marker table
In addition to the marker information displayed within the diagram grid, separate
marker tables may be added to the display. These tables provide the following
information for all active markers:
Table 6-2: Regular marker table
Label Information
Wnd Window type the marker is positioned in.
(Only if there is more than one window containing a phase noise dia-
gram.)
Type Marker type: N (normal), D (delta), T (temporary, internal)
Ref Reference (for delta markers)
Trc Trace to which the marker is assigned
X-value x-value of the marker
Y-value y-value of the marker
Understanding the Display Information
To Next Page
Loading...
