Trying Out the Instrument
R&S
®
FSWP
52Getting Started 1177.5756.02 ─ 13
5 Trying Out the Instrument
Overview of tutorials
Initial setup:
●
"Preparing the R&S FSWP" on page 54
●
"Selecting the phase noise application" on page 54
●
"Performing a preset" on page 54
Measurement selection
●
"Selecting a measurement" on page 55
The phase noise measurement
●
"Measuring phase noise" on page 56
●
"Measuring amplitude noise" on page 56
●
"Measuring spurs" on page 57
●
"Measuring spot noise" on page 57
●
"Measuring integrated noise" on page 58
The additive noise measurement
●
"How to measure additive noise" on page 58
The baseband noise measurement
●
"How to measure baseband noise at the RF input" on page 59
The pulsed phase noise measurement
●
"How to measure the phase noise of a pulse" on page 60
The pulsed additive noise measurement
●
"How to measure pulsed additive noise with an internally modulated pulse"
on page 61
Trace smoothing
●
"How to smooth the trace by averaging the measurement data" on page 63
●
"How to smooth the trace by adjusting the number of XCORR operations"
on page 63
●
"How to smooth the trace graphically" on page 64
●
"How to remove spurs from a trace" on page 64
To Next Page
Loading...
