Rohde & Schwarz FSWP - Lan; USB Ports; IF; Video; Demod Output; IF Wide out

Instrument Tour
R&S
®
FSWP
47Getting Started 1177.5756.02 ─ 13
●
DVI (digital visual interface)
For details, see Chapter 3.9, "Connecting an External Monitor", on page 24.
4.2.4 LAN
The R&S FSWP is equipped with a 1 GBit Ethernet IEEE 802.3u network inter-
face with Auto-MDI(X) functionality. The assignment of the RJ-45 connector sup-
ports twisted-pair category 5 UTP/STP cables in a star configuration (UTP stands
for unshielded twisted pair, and STP for shielded twisted pair).
For details, see the R&S FSWP user manual.
4.2.5 USB Ports
The four USB ports on the rear panel (type A) allow you to connect devices like
keyboards, mouses or memory sticks.
The male USB connector (type B) allows you to connect the R&S FSWP to a
computer and establish a remote control connection, for example.
All USB connectors support standard 2.0.
4.2.6 IF / Video / Demod Output
The two female BNC connectors can be used for various outputs:
●
Output of the intermediate frequency (IF)
●
Output of the video signal
Details about configuring the output type and characteristics are part of the user
manual.
Note that you can use this connector for applications available with the optional
spectrum analyzer hardware and analog modulation analysis application.
4.2.7 IF Wide Out
You can extend the signal analysis bandwidth of the R&S FSWP by installing a
hardware option. The bandwidth extension allows for a linear bandwidth up to
320 MHz.
The Rear Panel