Trying Out the Instrument
R&S
®
FSWP
71Getting Started 1177.5756.02 ─ 13
5. Configure the gate as required ("Gate Type", "Gate Level", "Gate Delay" and
"Gate Length").
The shape of the gate is represented by various lines and bars in the "Pre-
view" diagram that is part of the dialog box.
For more information on the gate configuration, refer to the R&S FSWP user
manual.
Tip: You can turn off the gate, if one is not required for the measurement.
To do so, select "Gate Type: Off".
5.4.4 Signal Generation
How to generate a CW signal
Some measurement setups require you to feed a signal into the DUT. You can
equip the R&S FSWP with an optional Signal Source that is able to generate such
a signal.
Available only for additive noise measurements and with the optional signal
source hardware component.
1. Enter the Additive Noise measurement.
2. Enter the "Overview" dialog box, and from there, enter the "Output" dialog
box.
3. Select the "Signal Source" tab.
4. Define the frequency and level of the CW signal in the corresponding input
fields.
Measurement Configuration
To Next Page
Loading...
