Trying Out the Instrument
R&S
®
FSWP
54Getting Started 1177.5756.02 ─ 13
5.1 Initial Setup
Preparing the R&S FSWP
1. Connect the R&S FSWP to an electrical outlet as described in Chapter 3.5,
"Connecting the AC Power", on page 20.
2. Turn on the R&S FSWP as described in Chapter 3.6, "Switching the Instru-
ment On and Off", on page 21.
Selecting the phase noise application
1. Select the [MODE] key.
2. Select the "Phase Noise" item in the "Mode" dialog box.
There's more than one way to skin a cat
In most cases, the firmware of the R&S FSWP provides several ways to
change measurement parameters. For example, the measurement range
can be defined via the [FREQ] key, the "MEAS CONFIG" key or the "Over-
view" dialog box.
All procedures in this chapter use the "Overview" dialog box as a starting
point (when possible). You can reach this dialog via the "Overview" softkey
displayed at the bottom of the softkey bar on the right side of the diagram
area.
Performing a preset
Before configuring and starting a new measurement, it is always recommended to
perform a preset and restore the default configuration of the instrument or the
measurement application.
1. Select the [PRESET] key on the front panel to restore the default state of the
R&S FSWP.
2. Enter the "Overview" dialog box and select the "Preset Channel" item to
restore the default state of the selected measurement channel. All other mea-
surement channels keep their custom configuration.
Initial Setup
To Next Page
Loading...
