Sample Application
R&S
®
SFE100
39Getting Started 2112.4122.62 ─ 13
3. In the tree, select the "MODULATION" submenu.
4. Press the ENTER key.
The focus is set on the work view.
5.
Activate the modulation.
a) Select the "MODULATION" field.
b) Press the ENTER key to display the list.
c) Select "ON".
d) Press the ENTER key to confirm the selection.
6. Select the "DIGITAL TV" signal source.
a) Select the "SIGNAL SOURCE" field.
b) Press the ENTER key to display the list.
c) Depending on the R&S SFE100 model, if not fixed, select "DIGITAL TV".
d) Press the ENTER key to confirm the selection.
7. Depending on the installed options, select the "DVB-C" transmission standard.
a) Select the "TRANSMISSION STANDARD" field.
b) Press the ENTER key to display the list.
c) Select "DVB-C".
d) Press the ENTER key to confirm the selection.
The selected standard is displayed in the info area.
The I/Q modulation is switched on, the internal coder is selected as the signal
source, and the DVB-C transmission standard is set.
To Next Page
Loading...
