Trying Out the Instrument
R&S
®
RTE
42Getting Started 1326.1026.02 ─ 08
3. To move the waveform back to the center of the screen, eliminate the offset in
the vertical settings:
a) Press the [Ch1] key again.
b) Enter 0
V in the "Offset" field.
The waveform is now displayed in the center of the display, with the x-axis
crossing at 0 V. The waveform can be unstable if the trigger level is above.
4. Tap the "Show signal bar" icon on the toolbar.
The signal bar disappears, and you can see the trigger level marker on the
right.
Changing the Waveform Scaling and Position
To Next Page
Loading...
