Remote Control Commands
R&S
®
SMA100B
472User Manual 1178.3834.02 ─ 05
Parameters:
<DPoint> DOT | COMMa
*RST: DOT
Example:
SENS:SWE:HCOP:DEV:LANG CSV
Selects output format *.csv.
SENS:SWE:HCOP:DEV:LANG:CSV:DPO DOT
Selects character dot for being used as decimal point.
Manual operation: See "Decimal Point" on page 259
:SENSe[:POWer]:SWEep:HCOPy:DEVice:LANGuage:CSV:HEADer <Header>
Defines whether each row (or column depending on the orientation) should be prece-
ded by a header containing information about the trace (see also :SENSe[:POWer]:
SWEep:HCOPy:DATA? on page 470).
Parameters:
<Header> OFF | STANdard
*RST: OFF
Example:
SENS:SWE:HCOP:DEV:LANG CSV
Selects output format *.csv.
SENS:SWE:HCOP:DEV:LANG:CSV:HEAD STAN
Selects the standard header for the *.csv file.
Manual operation: See "Row Header" on page 259
:SENSe[:POWer]:SWEep:HCOPy:DEVice:LANGuage:CSV:ORIentation
<Orientation>
Defines the orientation of the X/Y value pairs.
Parameters:
<Orientation> HORizontal | VERTical
*RST: VERTical
Example:
SENS:SWE:HCOP:DEV:LANG CSV
Selects output format *.csv.
SENS:SWE:HCOP:DEV:LANG:CSV:ORI VERT
Selects vertical orientation, the value pairs are written in a col-
umn like structure (separated by the selected separator, e.g. tab)
Manual operation: See "Orientation" on page 258
:SENSe[:POWer]:SWEep:HCOPy:DEVice:LANGuage:CSV[:COLumn]:SEParator
<Separator>
Defines which character is to separate the values, either tabulator, semicolon, comma
or blank.
Power Sensor Measurement Subsystems
To Next Page
Loading...
