Rohde & Schwarz SMAB-K24 - Page 575

Remote Control Commands
R&S
®
SMA100B
573User Manual 1178.3834.02 ─ 05
Parameters:
<Mode> USER | PREDefined
*RST: USER
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Carrier Frequency Mode" on page 144
[:SOURce<hw>][:ILS]:MBEacon:MARKer:FREQuency <Frequency>
Sets the modulation frequency of the marker signal for the ILS marker beacon modula-
tion signal.
Parameters:
<Frequency> 400 | 1300 | 3000
*RST: 400
Default unit: Hz
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Marker Frequency" on page 145
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:DEPTh <Depth>
Sets the modulation depth of the marker signal for the ILS marker beacon signal.
Parameters:
<Depth> float
Range: 0 to 100
Increment: 0.1
*RST: 95
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Marker Depth" on page 145
[:SOURce<hw>][:ILS]:MBEacon:PRESet
Sets the parameters of the ILS marker beacons component to their default values
(*RST values specified for the commands).
For other ILS preset commands, see [:SOURce<hw>]:ILS:PRESet on page 546.
Example:
SOURce1:ILS:MBEacon:PRESet
Usage: Event
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:PULSed <Pulsed>
Activates the modulation of a pulsed marker signal (morse coding).
SOURce Subsystem