Rohde & Schwarz TLx9 Series - Rack Design

Transmitter System R&S TLx9
R&S
®
TLx9
22System Manual 2506.5060.02 ─ 03
●
Common Remote Management over Web-Interface and SNMP
. All transmitters of
one redundancy system are:
– visible over the management interfaces as one system
– able to be controlled, monitored and managed by the operator of the TLx9 as
one system
●
Optionally integrated GPS receiver (fitting variant of the Exciter / GapFiller board)
●
Optionally integrated OCXO to provide hold over mode stability in SFN networks
for 24 h in case GPS or external 1 PPS signal fails (fitting variant of the Exciter /
GapFiller board)
●
For transmitter a transport stream feeding over ASI, IP over Gigabit Ethernet or
satellite receiver is possible
●
DVB-T/T2 receiver for retransmission or monitoring application to be optionally
integrated into the TLx9 system
●
DVB-S/S2 receiver module (with on-board CAM module and BTS recovery func-
tionality) to be optionally integrated into the TLx9 system
3.1.1 Rack Design
The TLx9 is an all-in-one solution which means a complete transmitter system is inte-
grated in a 19” x 1 or 2 HU housing (depending on the type) and minimal depth of max-
imum 600 mm in the power class of 5 W to 200 W.
Figure 3-1: TLx9 front view (1 HU)
Figure 3-2: TLx9 front view without air filter (2 HU)
Design and Function – R&S TLx9