Transmitter System R&S TLx9
R&S
®
TLx9
62System Manual 2506.5060.02 ─ 03
Rohde & Schwarz recommends the use of an double shielded RJ-45 cable which com-
plies with the CAT 6 specification
3.2.2.7 Connecting AC Power Supply
The instrument can be damaged by overvoltage. Make sure that the AC supply voltage
provided by your local power supply network complies with the specifications of the
power supply unit installed in your instrument.
Risk of electric shock
Check the power cable for damage.
Risk of fire
Make sure that the power cable has the appropriate current carrying capacity neces-
sary for power consumption over the entire temperature range.
●
Set the power switch on the rear of the instrument to 0 (OFF)
●
Connect the instrument to the power supply using the power cable
3.3 Commissioning R&S TLx9
Commissioning and operation of the transmitter system is described in the following
document. R&S® T
ransmitter System Tx9 Operating Manual Mat. No. 2109.91
10.02
Commissioning R&S TLx9
To Next Page
Loading...
