R&S ZVH Network Analyzer Mode (R&S ZVH-K42)
Evaluating the Results
Operating Manual 1309.6946.12 - 09 197
6.3.5 Using Limit Lines
When working with the magnitude format in the network analyzer, you can use limit
lines to set limits for level characteristics on the display that must not be exceeded.
You can create and edit limit lines with the R&S ZVHView software and load them into
the R&S ZVH via the USB or the LAN interface. The number of limit lines the R&S ZVH
can store in its memory depends on the number of other data sets on the R&S ZVH.
For more information see "Managing Datasets" on page 27 und "Using Limit Lines" on
page 150.
6.3.6 Using Trace Mathematics
Trace mathematics that subtract one trace from another are available for most
measurement formats in the network analyzer mode.
For more information see "Using Trace Mathematics" on page 144.
To Next Page
Loading...
