R&S ZVH Network Analyzer Mode (R&S ZVH-K42)
Vector Voltmeter (R&S ZVH-K45)
Operating Manual 1309.6946.12 - 09 198
6.4 Vector Voltmeter (R&S ZVH-K45)
With firmware option R&S ZVH-K45 (order no. 1304.5658.02) you can use a R&S ZVH
with tracking generator and VSWR bridge as a vector voltmeter.
A vector voltmeter performs reflection (S11) and transmission measurements (S21).
The tracking generator provides the signal source that generates an unmodulated
sinewave signal on a single frequency. Typical applications for a vector voltmeter are:
● adjustment of the electrical length of cables with a reflection measurement
● testing of the antenna elements of a phase-controlled antenna-array relative to a
reference antenna with a transmission measurement
► Press the MODE key.
► Press the "Vector Voltmeter" softkey.
The R&S ZVH starts the vector voltmeter mode. It turns on the tracking generator
and the zero span mode.
Screen layout of the vector voltmeter.
1 Result display
2 Hardware settings
3 Results: magnitude
4 Results: phase
5 Vector voltmeter softkey menu
To Next Page
Loading...
