Rohde AB100 - Fitting the drain connection

27 / 112 - EN -
Step Description Remark
6
Make sure the inlet tube is vertical and straight
from the sink to the sedimentation tank.
7
Additional adapters, pipes, hoses or fitting
material are available at any DIY or plumbing
store.
5.6.4. Fitting the drain connection
General safety information:
DANGER
Risk of property damage!
Do not use the sedimentation tank until the inlet and outlet connections have been fully
connected and checked for leaks.
NOTE
Under certain circumstances, the building's drainage system into the sewage system may
be higher than the drainage connection in the trap (Item 4) of the sedimentation tank.
In this case, the sedimentation tank must be raised.
⇒ The building's drainage system into the sewage system and the drain connection
of the trap (Item 4) must be at the same level.