Rohde TE Series - All Models Except Ecotop; Ecotop; Supply & Exhaust Air; Supply Air Handle

32 / 161 - EN -
5.5. Supply & exhaust air
5.5.1. Supply air handle
All models except Ecotop
All ROHDE Toploader models are equipped with an air supply handle on the kiln base.
Step
Action required
Illustration
1
When the handle points to the left, the air supply is cut
off.
2
When the handle points to the right, the air supply is
open.
Note:
You can significantly increase the service life of the heating elements by opening the air supply up to a temperature
of 600-700°C.
Ecotop
All ROHDE Toploader Ecotop models are equipped with an air supply handle on the lower right side of the kiln (near
the kiln base).
Step
Action required
Illustration
1
When the air supply handle is in the middle position, the
air supply is shut off.
2
When the air supply handle points to the left, the air
supply is open.
Note:
You can significantly increase the service life of the heating elements by opening the air supply up to a temperature
of 600-700°C.