Rohde TE Series - Maintenance & Cleaning; Maintenance; Re-tighten the Tensioning Belts

41 / 161 - EN -
Step
Action required
Illustration
4
To do this, loosen the supporting screw on the back.
5
Now you can lift the floor and place it horizontally on an
even surface. Do not place the floor vertically on its side!
Ecotop
Step
Action required
Illustration
1
If necessary, you can seperate the kiln stand from the
kiln.
2
Check the tensioning belts of the stainless steel kiln
casing beforehand and tighten them slightly if necessary.
3
To do this, loosen the supporting screws on the front.
4
To do this, loosen the supporting screws on the back.
5
You can now lift off the kiln body and store it upright on
a flat surface.