Rohde TE Series - Heating Elements

42 / 161 - EN -
7.4.2. Swivel kiln stand
Step
Action required
Illustration
1
We have designed a swivelling kiln stand (figure 17) that
will allow you to adjust the height to your own
requirements.
2
First detach the castors (only for models up to
TE 75 MCC+).
3
Now loosen the black plastic feet and remove them from
the kiln stand.
4
Finally remove the plastic cap from the upper part of the
kiln stand.
5
Check the tensioning belts of the stainless steel kiln
casing beforehand and tighten them slightly if necessary.
6
Applies only to Ecotop:
6.1) Make a note of or take a picture of which side the
floor insulation panel is placed facing up in the kiln
stand.
6.2) Carefully remove the floor insulation panel.
6.3) Carefully lay the panel flat on an even surface.