Roland AX-1 - AX-1 to E Series Keyboards Connection

AX-1 with “E” series keyboards (E-70, E-35, E-15)
(1) Connect AX-1 MIDI Out to MIDI In of the “E” series key-
board with a standard MIDI cable.
(2) First turn on “E” keyboard, then AX-1.
(3) Set reception of RX Only on MIDI Channel 1 of the “E”
keyboard.
(4) On the "E" keyboard, set reception of Program Change
and Volume on the Basic MIDI Channel to Off position.
(5) Set reception of the “E” keyboard of “Note to Arranger”
to Off position.
6) Selecting patches on AX-1 will enable using an additional
keyboard with the sounds contained inside the patches.
If you select a patch using section Lower of AX-1 or if you
start section Lower in any patch in which it is normally to
off position, section Manual Bass of the “E” keyboard will
then be started.
AX-TEE>ZU- Rt KF (E-70. E-35, E-
15) DiEf
(DAX-10 MIDI OUT & E 1!) — X «#-— #i- FO MIDI IN E ifj
HMDI y — TI TEHLET,
MEF. EY Y-Ke#—-H— FORMAN, MIC AX-10
"SAIL.
OEY I-X- E FO MIDI f + 7 A 1 Æ “RX Only" iz
BHELET
WEIU-R-+-#K- FT, TOIL Fr ONE
MIDI F + LRAVOKY a-LOADIEMELET,
6E #1) =. +E FO "Note to Arranger" OZt(á 4 712 L
()AX-1 TN Y FERRE. SY FLBENTUBSBUTEZ
)- X: +-#- FOMMEMK CEMTAET.
AX-1007- Ti 573 FERAY, WHO THAT
BIESNTWSZR y FDUT-EHLET BE, EU EE
4-#- FOV 227NNX-AR-t77a3VFMATAZIE
MTAET,
MIDI OUT
38
MIDI IN 4