Mastering Tools
Backing Module BK-7m
r
71
Parameters
The following parameters are located on the display
page that can be selected using [MENU] button‰
“MIDI” ‰ “Edit System” ‰ “Parameters”.
This page contains several parameters that are not
related to one another (the other MIDI pages always
concentrate on one aspect).
Save MIDI Set
This function allows you to save your changes to a
“User” memory for quick recall.
This function can be selected using [MENU] button ‰
“MIDI” ‰ “Save MIDI Set”.
1.
Edit the desired MIDI parameters (“Edit
Style Parts”, “Edit Song Parts”, “Edit Tone
Parts”, “Edit System”).
2.
Rotate the [CURSOR÷VALUE] dial to select
the MIDI Set where you want to save your
settings (“User1”~ “User8”).
3.
Press [WRITE] button to confirm.
A confirmation message informs you that the MIDI
Set has been saved.
Mastering Tools
The BK-7m contains two effects processors that apply
to all real time parts and Style and Song parts.
These processors are collectively called the “Mastering
Tools”, because they allow you to perfect the signal mix
to adapt it to the sound system you are using.
The parameters discussed here can be selected using
[MENU] button ‰ “Mastering Tools”.
SMF/Style Compressor
This multi-band compressor/limiter allows you to pro-
cess three frequency ranges separately. A compressor
reduces high levels (peaks) and boosts low levels,
smoothing out fluctuations in volume.
Parameter Setting Explanation
Rx Velocity On, 1~127 Allows you to switch
the reception (RX) of
velocity messages on
or off. If you don’t
need “On”, specify
which velocity value to
use instead of the con-
tinuous flux.
Rx Sysex Off, On Use this parameter to
specify whether the
BK-7m should receive
SysEx messages from
other devices.
Tx Sysex Off, On Use this parameter to
specify whether the
BK-7m should send
SysEx messages.
Tx Data Change Off, On This parameter allows
you to specify how the
original program
changes of the songs
you play back are
transmitted via MIDI.
The BK-7m may
change sound
addresses (usually
CC00 and CC32 values)
so as to play back all
songs with the best
possible quality. If you
switch this parameter
on, such real-time
transformations are
also transmitted via
MIDI. If you switch this
parameter off, the
original sound
addresses are trans-
mitted to the receiv-
ing device. (But the
BK-7m’s tone genera-
tor continues to
“enhance” the songs
you play back.)
Soft Thru Off, Global,
Piano
Select “Global” if the
BK-7m should transmit
all MIDI messages it
receives (using its MIDI
OUT socket).
Select “Piano” if you
wish to connect the
BK-7m to a digital
piano.
Parameter Setting Explanation
BK-7m_UK.book Page 71 Tuesday, January 4, 2011 9:25 AM
To Next Page
Loading...
