9
3-3 Installing a Blade
Installing the Blade
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
Be sure to support the tool mounting screw from below when installing the blade holder.
Cutting quality may become poor if installed without supporting the screw in this way.
NOTICE
1
Insert a blade into the blade holder until it snaps into
place with an audible click.
Push-pin
Blade holder
Blade
2
(1) Loosen the tool securing screw on the cutting
carriage.
(2) Support the tool-securing screw from below and
install the blade holder. Insert the blade holder
until the collar is flush with the carriage.
(3) Tighten the tool securing screw until the blade
holder is secured in place.
Cutting carriage
Loosen
Tighten
Tool securing screw
Depending on the material in use, it may be necessary to adjust the tip of the blade. For more information, see "3-7 Cutting Test."
To Next Page
Loading...
