Roland D-05 - Tone Parameters (Upper;Lower Tone Menu); TVA ENV Time (TVA Envelope Time); TVA ENV Level (Level)

16
Tone Parameters (Upper/Lower Tone Menu)
TVA ENV Time (TVA Envelop Time)
An envelope curve is determined by times and levels.
T1 T2 T3 T4 T5
SusLL3L2L1
Point 1
Point 3
Point 4
Point 5
EndL
Point 2
Key On Key O
S3 TVA ENV
T1 00 T2 00
T1 (Time 1)
Sets the time needed to reach point 1 from the moment the key
is pressed.
Value: 0–100
T2 (Time 2)
Sets the time needed to reach point 2 from point 1.
Value: 0–100
T3 (Time 3)
Sets the time needed to reach point 3 from point 2.
Value: 0–100
T4 (Time 4)
Sets the time needed to reach point 4 from point 3.
Value: 0–100
T5 (Time 5)
Sets the time needed to reach point 5 from the moment the key
is released.
Value: 0–100
TVA ENV Level (Level)
S3 TVA ENV
L1100 L2100
L1 (Level 1)
Sets the level of point 1.
Value: 0–100
L2 (Level 2)
Sets the level of point 2.
Value: 0–100
L3 (Level 3)
Sets the level of point 3.
Value: 0–100
SusL (Sustain level)
Sets the level of point 4.
Value: 0–100
EndL (End Level)
To lower the level after releasing the key, set this to 0, and to raise
the level, set it to 100.
Value: 0, 100
* The End Level remains until the key is released and played again.
That is, at a value of 100, the sound remains. However, the PMC
Sound Generator’s One-shot sounds do not remain even when
set to 100.
* If the levels of two adjacent points are set to similar values, the
time between these two points may prove to be shorter than
what is actually set, or even zero.
TVA ENV (Envelope)
S3 TVA ENV
Velo 00 TKF 00
Velo (Velocity Follow (Time 1))
Sets the sensitivity of the velocity than controls the Time 1 of the
TVA ENV. Increasing the sensitivity shortens Time 1, by stronger
playing.
Value: 0–4
TKF (Keyfollow (Time))
This can change the time o the TVA ENV depending on the key
played. 0 to 4 are valid. Higher values change the time more
drastically.
Value: 0–4