Roland D-05 - Tone Parameters (Upper;Lower Tone Menu); TVF MOD (TVF Modulation); TVA (Time Variant Amplifier)

15
Tone Parameters (Upper/Lower Tone Menu)
EndL (End Level)
To lower the level after releasing the key, set this to 0, and to raise
the level, set it to 100.
Value: 0, 100
* The End Level is retained until you release and play the key again.
* If the Levels of two adjacent points are set to similar values, the
time between these two points may prove to be shorter than
what is actually set, or even zero.
TVF MOD (TVF Modulation)
S3 TVF Mod
LFO +1 LFOD 00
LFO (LFO Select)
Selects the LFO that changes cuto point periodically (creating
growl eects).
Value: +1, -1, +2, -2, +3, -3
Positive Phase (+)
Negative Phase (-)
Indication LFO (Phase)
+1 LFO-1 (+)
-1 LFO-1 (-)
+2 LFO-2 (+)
-2 LFO-2 (-)
+3 LFO-3 (+)
-3 LFO-3 (-)
LFOD (LFO Depth)
Sets the depth of a growl eect. Higher values deepen the eect.
Value: 0–100
Aftr (Aftertouch Range)
Sets the sensitivity of the aftertouch that controls the cuto point.
“-” values lower the cuto point by stronger Aftertouch, and “+”
values raise it.
Value: -7–+7
TVA (Time Variant Amplier)
TVA
S3 TVA
Levl 80 Velo+10
Levl (Level)
Sets the volume of a Partial. Higher values may cause sound
distortion. If so, lower the value. Even when the Level is set to zero
here, the sound may not be completely muted if the TVA ENV
curve is high.
Value: 0–100
Velo (Velocity Range)
Sets the sensitivity of the velocity that controls the volume of the
sound. “-” values lower the level by harder playing, and “+” values
raise the level by harder playing.
Value: -50–+50
BP (Bias Point)
You can change the overall volume of the keyboard (= bias level)
from the set level, and set the range (bias direction) where the
bias level is valid.
This bias range is where the bias level is valid on the keyboard. It
can be set with the bias point (Where he bias range begins) and
bias direction ( < or > ).
Value: <A1–<C7, >A1–>C7
Display Example Function Example
>C4
The bias level is only valid on the keyboard above the C4
key.
<C4
The bias level is only valid on the keyboard below the C4
key.
BLvl (Bias Level)
The curve ( bias level ) can be set. Lower values make the curve
steeper.
Value: -12–0
Volume Adjustment
0
Angle
C6
Value
Bias Point: >C6