31
Parameter List
Patch Factors
Settings Common to All Screens
(PATCH TOP) (p. 2)
KEY MODE Key Mode
WHOLE, DUAL, SPLIT, SEP,
WHOL-S, DUAL-S, SPL-US,
SPL-LS, SEP-S
SPLIT Split Point C2–C7
BALANCE Tone Balance 0–100
TRANSPOSE Transpose -36–+36
Chase Switch Chase Switch OFF, ON
Portamento Switch Portamento Switch OFF, ON
CONTROL
(p. 3)
Bend Bender Range 0–12
AfterPB Aftertouch Bend Range -12–+12
Hold Hold Mode U, L, UL
Time Portamento Time 0–100
Mode Portamento Mode U, L, UL
OUTPUT
(p. 4)
Mode Output Mode 1–4
RevType Reverb Type 1–32
Revbal Reverb Balance 0–100
Vol Total Volume 0–100
CHASE
(p. 4)
Mode Chase Mode UL, ULL, ULU
Level Chase Level 0–100
Time Chase Time 0–100
TONE TUNE
(p. 5)
LKey L-Tone Key Shift -24–+24
UKey U-Tone Key Shift -24–+24
LTun L-Tone Fine Tune -50–+50
UTun U-Tone Fine Tune -50–+50
MIDI
(p. 5)
TxCH Transmit CH B, 1–16
TxPC
Transmit Program
Change
O, 1–100
SepCH
Separate Mode Receive
CH
O, 1–16
Tone Parameters
Common Parameters
Struct
(p. 8)
Structure Struct Structure 1–7
P-ENV
(p. 8)
P. ENV
Velo Velocity Range 0–2
TKF Time Keyfollow 0–4
P-ENV Time
T1 Time1 0–50
T2 Time2 0–50
T3 Time3 0–50
T4 Time4 0–50
P-ENV Level
L0 Level0 -50–0–+50
L1 Level1 -50–+50
L2 Level2 -50–+50
SusL Sustain Level -50–+50
EndL End Level -50–+50
Pitch Mod
LFOD LFO Depth 0–100
Lever Pitch Lever Modulation 0–100
Aftr
Pitch Aftertouch
Modulation
0–100
LFO
(p. 9)
LFO-1
Wave Waveform TRI, SAW, SQU, RND
Rate Rate 0–100
Delay Delay Time 0–100
Sync Sync. O, On, KEY
LFO-2
Wave Waveform TRI, SAW, SQU, RND
Rate Rate 0–100
Delay Delay Time 0–100
Sync Sync. O, On
LFO-3
Wave Waveform TRI, SAW, SQU, RND
Rate Rate 0–100
Delay Delay Time 0–100
Sync Sync. O, On
EQ
(p. 10)
EQ
LowFreq Low Frequency
63, 75, 88, 105, 125,
150, 175, 210, 250,
300, 350, 420, 500,
600, 700, 840
LowGain Low Gain -12–+12
HiFreq High Frequency
250, 300, 350, 420,
500, 600, 700, 840,
1.0, 1.2, 1.4, 1.7, 2.0,
2.4, 2.8, 3.4, 4.0, 4.8,
5.7, 6.7, 8.0, 9.5
HiQ High Q
0.3, 0.5, 0.7, 1.0, 1.4,
2.0, 3.0, 4.2, 6.0
HiGain High Gain -12–+12
To Next Page
