5
Basic Operation
Time
(Chase Time)
Adjusts the sounding time. Higher value is longer time.
Value: 0–100
TONE TUNE
The relative pitch of the Upper and the Lower Tones can be
separately set. By setting slightly dierent pitches, a detune eect
can be obtained. Also, by lowering the pitch of the Upper Tone,
and raising the pitch of the Lower Tone, the pitches of the Two
Tones can become exactly the same.
Neo Horizon
LKey 00 Ukey 00
LKey
(Key Shift of the Lower Tone)
Allows you to shift the pitch of the Lower Tone in semi-tone steps.
Value: -24–+24 (+/- 2 octave)
UKey
(Key Shift of the Upper Tone)
Allows you to shift the pitch of the Upper Tone in semi-tone steps.
Value: -24–+24 (+/- 2 octave)
LTun
(Fine Tuning of the Lower Tone)
Allows you to Tune the pitch of the Lower Tone.
Value: -50–+50 (approx. +/- 2 cents)
UTun
(Fine Tuning of the Upper Tone)
Allows you to Tune the pitch of the Upper Tone.
Value: -50–+50 (approx. +/- 2 cents)
MIDI
(MIDI Functions)
You can change the setting of the MIDI Functions included Patch
Factor as follows.
MIDI Edit
TxCH B TxPC OFF
TxCH
(Transmit Channel)
The transmit channel of each Patch can be set to a deferent
number from the basic channel (“Function Menu” 0 “MIDI”
0
“CH” parameter). At B, the channel number is the same as the
Basic Channel.
Value: B (Basic), 1–16
TxPC
(Transmit Program Change Number)
A Program Change number to be transmitted can be set for
each patch individually. At OFF, the Program Change number
preprogrammed in each Patch is transmitted.
Value: OFF, 1–100
SepCH
(Receive Channel in Separate Mode)
A receive MIDI Channel in separate mode can be set for each
Patch individually. At OFF, the receive channel set in MIDI
Functions commonly set for System Function is used (“Function
Menu” 0 “MIDI”
0
“SepCH” parameter).
Value: OFF, 1–16
To Next Page
Loading...
Need help?
General
Weight and Dimensions
