Roland HandSonic HPD-20 - Page 21

What is the HandSonic? Quick Guide Frequently Used Functions Parameter Guide Appendix
21
Exporting a recorded performance as an audio le
* Connect your USB ash drive before you continue.
1.
Stop recording or playback, and then press the [F3] (EXPORT) button.
The EXPORT screen will appear.
2.
Note the le name, and adjust the tempo.
The le will be saved with the name that’s shown here.
If you sound the metronome, the tempo will be displayed, allowing you to adjust
the tempo.
Use the value knob to adjust the tempo.
As necessary, use the cursor [
] [ ] buttons to select the following parameters,
and use the value knob to set the values.
Parameter Explanation
Post Export Time
In some cases, the reverberant decay at the end of the exported
audio le may be cut o. If this occurs, you can increase this
value so that the reverberant decay will not be cut o.
Export Gain
While reading the output level meter, adjusts the volume of the
audio le.
Positive (“+”) values will increase the volume.
Press the [F1] (PREVIEW) button to audition the performance.
3.
Press the [F3] (EXECUTE) button.
Exporting to the USB ash drive will begin.
When export is completed, the screen will indicate “Completed!”
* The audio le will be saved in the top level (root) of the USB ash drive.
NOTE
Do not strike the HandSonic’s pads during the export.
The vibration may cause unexpected errors.
4.
Press the [KIT] button to return to the kit screen.
1
Output level for
the export
3
“Rear Panel (Connections)” (p. 8)