Roland HandSonic HPD-20 - Adjusting the Roll Speed (Roll Speed); Kit Prm; Adjusting the Volume of the Entire Kit; (Kit Volume)

What is the HandSonic? Quick Guide Frequently Used Functions Parameter Guide Appendix
KIT
49
PAD CONTROL–ROLL
MENU g KIT g PAD CTRL g ROLL
These settings are made for each pad.
Parameter Explanation
Adjusting the roll speed (Roll Speed)
* This cannot be set for external expansion pads.
* You can also set this by holding down the [SHIFT] button and pressing the [ROLL] button.
Roll Speed
If the [ROLL] button is on, pressing down on a pad will change the roll speed. Higher values will make the roll faster.
If this is set to a note value, the roll will be synchronized to the tempo. If this is “OFF,” a roll will not occur.
KIT PRM
KIT COMMON
MENU g KIT g KIT PRM g COMMON
Parameter Explanation
Adjusting the volume of the entire kit (Kit Volume)
For details, refer to p. 31.
Kit Volume Adjusts the volume of the entire kit.
Adjusting the volume of the hi-hat control pedal (Pedal Hi-Hat Volume)
Pedal Hi-Hat Volume
Adjusts the volume of the foot-close sound when you press the hi-hat control pedal.
* The volume of the instrument assigned to the hi-hat control pedal is adjusted by “Volume” (p. 25).
Adjusting the sensitivity of the pads (Pad Sensitivity)
For details, refer to p. 31.
Pad Sensitivity
Adjusts the sensitivity of all pads (M1–M5, S1–S8) simultaneously.
Set this to a lower value if you’re using your hand to strike the pads.
Set this to a higher value if you’re using your ngers, or if a child will be playing the HandSonic.
REALTIME MODIFY
MENU g KIT g KIT PRM g RT MODIFY
Parameter Explanation
Realtime modify knob settings
These parameters specify what the realtime modify knob will do if the [PITCH] or [EFFECT] button is pressed.
* You can also make these settings by holding down the [SHIFT] button and pressing the [PITCH] or [EFFECT] button.
Pitch Default
Species the initial amount of pitch change that will be applied when you press the [PITCH] button.
The amount of pitch change specied here will be applied even if you don’t turn the realtime modify knob.
Eect Select Selects the multi-eect that will be controlled by the realtime modify knob.
Default ...
Species the initial amount of multi-eect parameter change that will be applied when you press the [EFFECT]
button. The change you specify here will be applied even if you don’t turn the realtime modify knob.
* The parameter name will change depending on the multi-eect type.