Roland INTEGRA-7

Editing a Studio Set
Introduction Playing/Creating Sounds Use with a Computer Overall Settings Appendix
Quick Guide
Initializing a Part
This operation will initialize the part settings of the current part.
1. From the top screen or the STUDIO SET EDIT screen, press
the [MENU] button.
2. Choose “PART INIT” and press the [ENTER] button.
A message will ask “Are you sure?”
3. To initialize, choose “OK” and press the [ENTER] button.
Initializing the Sound Controls
This operation will initialize the following oset parameters that
aect how each part sounds.
• Cuto Oset
• Resonance Oset
• Attack Oset
• Decay Oset
• Release Oset
• Vibrato Rate
• Vibrato Depth
• Vibrato Delay
1. From the top screen or the STUDIO SET EDIT screen, press
the [MENU] button.
2. Choose “SOUND CTRL INIT” and press the [ENTER] button.
A message will ask “Are you sure?”
3. To initialize, choose “OK” and press the [ENTER] button.
Initializing a Studio Set
Here’s how to initialize the currently selected Studio Set.
1. From the top screen or the STUDIO SET EDIT screen, press
the [MENU] button.
2. Choose “STUDIO SET INIT” and press the [ENTER] button.
A message will ask “Are you sure?”
3. To initialize, choose “OK” and press the [ENTER] button.
37