136
Chapter 5 Feature Reference Chapter 5 Feature Reference
5-12 Viewing Information about the Media and the System
Displaying the Amount of Media Remaining
Procedure
Press .
Press
several times.
Press .
Press
.
Press .
Use
to set the amount of media re-
maining.
Press
to enable the setting.
Press to go back to the original screen.
Description
You can display how much of the media in use is left. Once you set the amount of media remaining,
the amount remaining is displayed at the top menu until it reaches zero. If you cancel the setup such
as by removing the media, the amount remaining at that time ashes on the screen.
The amount of media remaining is not updated automatically when you change the media. Redo the
setting whenever you change the media. Note, however, that when sheet media is loaded (that is,
when [SETUP SHEET] is set to "PIECE"), the setting for the amount of remaining media is made auto-
matically.
You can also make the setting display this menu automatically whenever you change the media. See
the next section, "Verifying the Setting for the Amount Remaining Every Time the Media Is Changed."
Note: The remaining amount that is displayed is only an estimate, and its accuracy is not assured.
To Next Page
Loading...
Need help?
General