58
Chapter 3 Operation of the Media Take-up System
3-2 Using the Media Take-up System
Loading Roll Media
1.
Pass the media through the printer.
Move the dancer roller toward the rear.
Load the roll media.
P.35, "Loading Media"
Pull back the loading lever.
The media is secured in place.
2.
Fasten the media to the paper tube.
When you attach the paper tube, insert it securely onto the end caps on the take-up unit. For informa-
tion on how to install it, refer to the Setup Guide.
Use to select "TU."
Press .
The screen shown in the gure appears.
To Next Page
Loading...
Need help?
General