Installing the Ink Cartridges
12
1. Changes to the Setup Guide1. Changes to the Setup Guide
6.
When this screen appears, pull out the dummy cartridges
, and press .
REMOVE DUMMY CRT.
SLOT: 3,4
SET CL-LIQUID
3 4
7. When a new slot number is displayed, repeat the procedure from Steps 3to 6 using the cleaning cartridge
you just pulled out.
Repeat until the following menu is displayed.
8. Make sure the drain bottle is installed, and press .
Cleaning is nished.
3. Insert the ink cartridges for the respective colors.
1.
Before inserting ink cartridges, shake each of them 50 times (about 15 seconds).
The precipitation of the ingredients in the ink disables printing in normal color. To allow the ingredients to be mixed well,
shake each ink cartridge horizontally from side to side by 5 cm (2 inches) from each end of the ink cartridge.
To Next Page
Loading...
