Important Notes on Handling and Use
This machine is a precision device. To ensure the full performance of this machine, be sure to
observe the following important points. Failure to observe these may not only result in loss of
performance, but may also cause malfunction or breakdown.
This Machine is a Precision Device.
Handle carefully, and never subject the machine to impact or excessive force.
Never print material outside the range of specications.
Install in a Suitable Location
Install in a location having the specied temperature and relative humidity.
Install in a quiet, stable location oering good operating conditions.
Never use the machine in an environment where silicone substances (oil, grease, spray, etc.) are present.
Doing so may cause poor switch contact.
When Moving the Machine
When moving the machine, be sure to support it at the bottom using two hands. Attempting to move the
machine by holding it at a dierent location may result in damage.
When moving the machine to another location, be sure to attach the retainers. Attempting moving without
attaching the retainers may result in damage.
Printing
Never attempt to perform printing on the edges or over holes in printing material.
Printing results may vary according to the original data, the material printed, and the details of settings.
Before you perform actual printing, we recommend carrying out test printing.
Attempting printing with no material loaded may damage the pin or heads.
To Next Page
Loading...
Need help?
General