Roland Metaza MPX-90M - 3-2 Adjustment; Adjusting Pin Striking Force

49
Chapter 3 Maintenance and Adjustment
3-2 Adjustment
Adjusting the Striking Force of the Pin
You can adjust the striking force of the pin by using MPX-90M Head Manager. Pin adjustment involves striking
the pattern shown in the gure. Prepare a piece of test-use printing material (brass) or other material measur-
ing about 60 mm (2.3 in.) by 60 mm (2.3 in.).
Procedure

Start MPX-90M Head Manager.
 P. 22, "How to Start The Software"

Switch on the power to the machine.
 P. 27, "STEP1: Switching On the Power"

Click [Readjust Pin].
Follow the on-screen instructions to perform adjust-
ment for the pin.
 Set a material to be imprinted with a test pattern
using the adhesive sheet and table.
 Use a head cap.
 P. 35, "STEP 1: Loading the Instrument to be Im-
printed"
If the adjustment pattern fails to be printed, see the
sections given below.
 P. 67, "The printed location isn't where desired"

When you have nished, click
.
The window closes.
Adjustment pattern