42
2-2 Starting Printing
Chapter 2 Printing
3.
Fix the height of the head. (Only when no head cap is used)
Press the Power/Movement button.
The head moves and stops at the position where the tip of the head cap rides on the surface of the
instrument to be imprinted.
Loosen the head's stopper.
Lower the stopper to the bottom.
Fix the stopper.
Align the center of the knob with the top of the
triangle right below.
The center of the knob must
be positioned immediately
above the top of the triangle.
Power/Movement
button
Loosen
To Next Page
Loading...
