54
3-3 The Replacement of the Consumable Parts
Chapter 3 Maintenance and Adjustment
Switch on the power to the machine.
P. 27, "STEP1: Switching On the Power"
Click [Replace Head].
Follow the on-screen instructions to perform adjust-
ment for the pin.
Set a material to be imprinted with a test pattern
using the adhesive sheet and table.
Use a head cap.
P. 35, "STEP 1: Loading the Instrument to be Im-
printed"
If the adjustment pattern fails to be printed, see the
sections given below.
P. 67, "The printed location isn't where desired"
When you have nished, click .
The window closes.
To Next Page
Loading...
