Roland OCTAPAD SPD-20 PRO - Page 29

29
Other Functions
3. Use the [–][+] buttons to select the data that you
want to load, and then press the [ENTER] button.
%[ENTER]
4. Press the [ENTER] button to load the data.
All data saved in the OCTAPAD is loaded into the OCTAPAD.
If you decide to cancel, press the [EXIT] button.
NOTE
When all data is loaded, all data in the OCTAPAD is overwritten. Any
important data should be backed-up beforehand.
DelAll
1. Access the USB MEMORY screen (p. 28).
2. Select “DelAll” and then press the [ENTER] button.
3. Use the [–][+] buttons to select the data that you
want to delete, and then press the [ENTER] button.
%[ENTER]
4. Press the [ENTER] button to delete the data.
If you decide to cancel, press the [EXIT] button.
SaveKit
1. Access the USB MEMORY screen (p. 28).
2. Select “SaveKit” and then press the [ENTER] button.
3. Use the [–][+] buttons to select the kit that you
want to save, and then press the [ENTER] button.
4. Use the [–][+] buttons to specify the save-
destination, and then press the [ENTER] button.
%[ENTER]
5. Press the [ENTER] button to save the data.
If you decide to cancel, press the [EXIT] button.
LoadKit
1. Access the USB MEMORY screen (p. 28).
2. Select “LoadKit,” and then press the [ENTER] button.
3. Use the [–][+] buttons to select the kit that you
want to load, and then press the [ENTER] button.
4. Use the [–][+] buttons to select the load-destination
in the OCTAPAD, and then press the [ENTER]
button.
%[ENTER]
5. Press the [ENTER] button to load the data.
If you decide to cancel, press the [EXIT] button.