Roland OCTAPAD SPD-20 PRO - Adjusting the Signal Level of the OUTPUT Jacks and PHONES Jack; Setting the AUTO off Function; Viewing the Version

31
Other Functions
Adjusting the Signal Level of the OUTPUT Jacks
and PHONES Jack
1. Press the [SYSTEM] button.
2. Use the [K][J] buttons to select “SOUND/CTRL,” and
then press the [ENTER] button.
3. Use the [K][J] buttons to select “OutGain.”
4. Use the [–][+] buttons to select the value.
* If you raise “OutGain” excessively, the sound might distort.
Setting the AUTO OFF Function
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto
O function). If you do not want the power to be turned o
automatically, disengage the Auto O function.
To restore power, turn the power on again (p. 11).
1. Press the [SYSTEM] button.
2. Use the cursor buttons to select “OPTION,” and then
press the [ENTER] button.
3. Use the [K][J] buttons to select “AutoO.”
4. Use the [–][+] buttons to set the auto o function.
Value Explanation
OFF The power does not turn o automatically.
4 HOURS
When four hours have elapsed without any pad
being struck or any operation being performed, the
unit will turn o automatically.
If you specify 4 HOURS, the message “Turn O If Not Used for 4
Hours.” appears; press [ENTER].
Viewing the Version
Here’s how to view the program version.
1. Press the [SYSTEM] button.
2. Use the [K][J] buttons to select “VERSION,” and
then press the [ENTER] button.