Roland OCTAPAD SPD-20 PRO - Formatting a USB Flash Drive; Other Functions; Adjusting the Display Contrast; Restoring the Factory Settings

30
Other Functions
DelKit
1. Access the USB MEMORY screen (p. 28).
2. Select “DelKit” and then press the [ENTER] button.
3. Use the [–][+] buttons to select the data that you
want to delete, and then press the [ENTER] button.
%[ENTER]
4. Press the [ENTER] button to delete the data.
If you decide to cancel, press the [EXIT] button.
Formatting a USB Flash Drive
NOTE
When you format a USB ash drive, all data on the USB ash drive
is erased.
1. Access the USB MEMORY screen (p. 28).
2. Select “Format,” and then press the [ENTER] button.
A conrmation screen appears.
3. Press the [ENTER] button once again.
4. Press the [ENTER] button to format the USB ash
drive.
If you decide to cancel, press the [EXIT] button.
Other Functions
Adjusting the Display Contrast
1. Press the [SYSTEM] button.
2. Use the [K][J] buttons to select “OPTION,” and then
press the [ENTER] button.
3. Use the [K][J] buttons to select “LcdContrast.”
4. Use the [–][+] buttons to select the value.
Restoring the Factory Settings
1. Press the [SYSTEM] button.
2. Use the [K][J] buttons to select “FACTORY RESET,”
and then press the [ENTER] button.
3. Press the [ENTER] button to execute FACTORY
RESET.
If you decide to cancel, press the [EXIT] button.
NOTE
When you execute this operation, all data and settings in the
OCTAPAD is lost. In advance, you should back up any important data
or settings to a USB ash drive (p. 28).