Additions and Changes to the User's Manual
21
Addition: Procedure from Preparing to Move to Reinstallation (P. 170 to P. 175)
The following procedure has been added to facilitate the use of the "CIRCULATE INK" menu
for movement preparation when you are using eight colors (CMYKLcLmLkW). This procedure
is not necessary if you are using seven colors (CMYKLcLmLk) or four colors (CMYK), so skip
this procedure in these situations.
* After performing the procedure under "1. Remove any media and the blade holder.," perform
the following operations.
2. Only when using white ink: Circulate the ink.
* This work is not necessary when using seven colors (CMYKLcLmLk) or four colors (CMYK).
Proceed to step
3.
("Enter the menu for discharging the wiper tray cleaning liquid.").
A
Press [MENU].
B
Press [ ] several times to display the screen shown below.
MENU
SUB MENU
C
Press [ ] once, and then press [ ] several times to display the screen shown below.
SUB MENU
INK CONTROL
D
Press [ ] once, and then press [ ] several times to display the screen shown below.
INK CONTORL
CIRCULATE INK
E
Press [ENTER].
The screen shown in the following gure appears, and then the ink circulation starts. The
(approximate) remaining time for the procedure is displayed on the screen. (The display
shown below is an example. "01:45" = "1 minute and 45 seconds")
CIRCULATING INK
>> 01:45
Depending on the timing with which the ink circulation is started, the following screen may
be displayed and cleaning may start. When cleaning is complete, the ink circulation will
start, so wait for the ink circulation to complete. (The display shown below is an example.
"01:45" = "1 minute and 45 seconds")
CLEANING...
>> 01:45
When nished, the screen shown below appears again.
INK CONTORL
CIRCULATE INK
To Next Page
Loading...
