21
Editing a Drum Kit
Editing with the [KIT EDIT] Button
1. Press the [DRUM KIT] button.
The DRUM KIT screen appears.
2. Turn the dial to select the drum kit that you
want to edit.
3. Press the [KIT EDIT] button.
The KIT EDIT screen appears.
4. Strike the pad that you want to edit.
To select the rim of a pad, strike the rim.
MEMO
By holding down the [ENTER] button and pressing the
[SYSTEM] button
, you can prevent the pad you’re editing
from being switched. This is convenient if you’re playing a
phrase while you edit.
5. Use the cursor buttons to select the parameter
that you want to edit, and press [ENTER]
button.
Parameter
Explanation
TRANSIENT
Adjusts the attack and release of the
instrument (transient).
INSTRUMENT Changes the type of instrument.
PAD VOL Adjusts the volume of each pad.
PAD EQ
Adjusts the tonal character of each pad
(pad equalizer).
PAD COMP
Adjusts the dynamics of each pad
(pad compressor).
OVERHEAD
Adjusts the sound of the overhead mics that
capture the entire drum kit.
ROOM
Simulates the reverberation and resonance
of the location in which you’re playing the
drums.
MFX
Lets you apply up to three eects to the drum
kit.
MASTER COMP Adjusts the overall dynamics of the drum kit.
MASTER EQ
Adjusts the overall tonal character of the
drum kit.
&For details, refer to “TD-27 Data List” (PDF).
MEMO
An audio le that you created on your computer can be
loaded from the SD card into the TD-27, and played as an
instrument (p. 22).
6. Use the dial to change the settings.
7. Press the [DRUM KIT] button to return to the
DRUM KIT screen.
Reference
5 In screens where the [F5] (H & R) button is shown, you
can individually edit the parameters for each dierent
striking location, such as the head and the rim.
5 You can layer two instruments together, or switch
between them according to the force of the strike
(SUB INSTRUMENT).
&For details, refer to “Reference Manual” (PDF).
To Next Page
Loading...
