Roland V-Drums TD-27 - System Settings - Auto Off and Factory Reset; Setting the AUTO OFF Function; Restoring Factory Settings

26
Various Settings (SYSTEM)
7. Use the cursor buttons to select “OK,” and press
the [ENTER] button.
The backup data is loaded from the SD card.
Setting the AUTO OFF Function
The power to this unit will be turned o automatically after
a predetermined amount of time has passed since it was
last used for playing music, or its buttons or controls were
operated.
If you do not want the power to be turned o automatically,
disengage the AUTO OFF function.
* To restore power, turn the power on again.
1. Press the [SYSTEM] button.
The SYSTEM screen appears.
2. Use the cursor buttons to select “AUTO OFF,”
and press [ENTER] button.
The AUTO OFF screen appears.
3. Use the dial to specify the setting of the AUTO
OFF function.
Setting Explanation
OFF The power does not turn o automatically.
4 HOURS
When four hours have elapsed without any pad
being struck or any operation being performed,
the unit will turn o automatically.
MEMO
If the AUTO OFF function is set to “4 HOURS,” the message
“WARNING: AUTO OFF, The TD-27 will turn o in 30 min.”
appears 30 minutes before the power turns o.
4. Press the [DRUM KIT] button to return to the
DRUM KIT screen.
Restoring the Factory Settings
The “Factory Reset” operation returns all data and settings
stored in the TD-27 to their factory-set condition.
NOTE
When you execute this operation, all data and settings
in the TD-27 will be lost. Before you proceed, you should
save any important data and settings to your SD card
(p. 25).
1. Press the [SYSTEM] button.
The SYSTEM screen appears.
2. Use the cursor buttons to select “FACTORY
RESET,” and press [ENTER] button.
The FACTORY RESET screen appears.
MEMO
If you want all user samples to also be returned to
their factory-set state, use the dial to add a check mark
to “Reset with User Sample.” All user samples in user
memory are overwritten by the factory-set data.
3. Press the [F5] (FACTORY RESET) button.
A conrmation message appears.
If you decide to cancel, select “CANCEL” and press the
[ENTER] button.
4. Use the cursor buttons to select “OK,” and press
the [ENTER] button.
The “Factory Reset” operation will be executed.